FPGA Logic Analyzer Add-Ons
2.5 - 5.0V Input Stage Using TI SN74ALVTH16244
This add-on was contributed by Richard T. Stofer. The text below ist mostly taken from his e-mail. The board has not yet been tested over the full frequency range of the analyzer.
In the top right corner there is a set of pin rows for a 40 pin right angle header that will plug in to port B1. Just below and to the right are two 0805 capacitor layouts. One is a 10µF tantalum and the other a 0.1µF ceramic. Along the center of the layout are four more capacitors. The one on the far left is a 10µF tantalum and the remaining three are 0.1µF ceramic. The three ICs are TI SN74ALVTH16244 (SSOP).
Now to the connectors along the lower edge: the upper pair is a female 40 pin header while the lower rows are pin headers. The female header allows to connect to prototype boards with male-male jumpers. The next row is entirely ground connections and is labeled on both ends. The next two rows are signals and the first signal is next to the pin marked '1' (on the right end) and the next signal is adjacent to '2'. The signals continue along this pair of rows, extending left, until signals 31 and 32. Finally, the lower row of pins are all grounded.
Over at the left column of pins the clock output is routed to all 4 ungrounded pins and labeled.